TM-9-1290-365-24&P Technical and Parts Manual for Paladin Muzzle Velocity System M93 Upgraded Download
Page 283 of 334
ARMY TM 9-1290-365-24&P SECTION IX. MICROWAVE TEST EQUIPMENT, DESCRIPTION AND CALIBRATION SECTION CONTENTS Subject Page General.................................................................................................................................................. D-113 Operation Description ........................................................................................................................... D-113 Test Equipment Calibration.................................................................................................................. D-1 17 D.9.1 General. D.9.1 .1 SCOPE . This section describes the microwave test equipment (MTE) that is used for testing of the M93 transceiver assembly P/N’s AY6707292-O, AY6707292-4, and AY6707292-5. This MTE is also used on testing the M94 transceiver assembly P/N’s AY6706571-O and AY6706571-2. For the M94 transceiver assembly, refer to TM 9-1290-364-24&P, Appendix D, Section 10. D.9.1.2 PURPOSE . The purpose of this section is to provide the calibration and maintenance procedures for the MTE. D.9.2 Operation Description. D.9.2.1 PURPOSE . The purpose of the MTE is to demonstrate that the RF Section of the transceiver assembly complies with the requirements. D.9.2.2 TESTED REQUIREMENTS . The following performance requirements of the transceiver assembly are tested using the MTE: a. Transmitted power b. Transmitted frequency c. Receiver sensitivity D.9.2.3 EQUIPMENT DESCRIPTION . The MTE is composed basically of two types of equipment: a. Standard Measurement Equipment (SME) b. Microwave Measurement Equipment (MME) D.9.2.3.1 STANDARD MEASUREMENT EQUIPMENT . Unless otherwise specified, the standard mea- surement equipment (SME) listed in Table D-24. is used for testing the transceiver assembly. Each SME can be replaced by equipment equivalent to the one listed with same or better performance. D-113