TM-9-1290-365-24&P Technical and Parts Manual for Paladin Muzzle Velocity System M93 Upgraded Download
Page 260 of 334
ARMY TM 9-1290-365-24&P D.7.11 MVP CCA Reassembly. D.7.11.1 ACCELERATION SWITCH REASSEMBLY . DELETED D.7.11.2 DSP REASSEMBLY . Refer to Figure D-30. a. Carefully insert DSP (4) to the socket (7). Pay attention to the correct orientation of the component. b. Install housing (6) and thermal sheet (5). Use number of thermal sheets (5) as required to eliminate any space between the DSP (3) and the housing (6). c. Install and fasten four screws (8), four lock washers (9), eight flat washers (10), and four nuts(11). D.7.11.3 REPLACEMENT OF PREPROGRAMMED COMPONENTS . Refer to Figure C-7. For replacement of faulty programmed EPROMs U24, U25, U26, and PAL U13, refer to para. D.7.14 for programming procedures. 0.7.11.4 INSTALLATION . Install MVP CCA lAW para. D.4.11.2. D.7.1 2 Testing. CAUTION The MVP CCA contains components subject to damage by electrostatic discharge. Use approved grounding procedures before touching, removing, or inserting CCA. NOTE Hereafter, the MVP CCA will be referred to as the Unit Under Test (UUT). D.7.12.1 GENERAL D.7.12.1.1 MVP CCA Test Procedures. The test setup provided in Figure D-33., shows the equipment used and cable hookup for the test procedure. Figures D-34. and D-35. are detailed illustrations of the special testers. D.7.12.1.2 Test Data Sheets. The test data sheets in Table D-18. are to be reproduced locally, as required, for recording the test results. The test data sheets must be completed each time a test section is performed. The completed test data sheets shall be retained and used as a troubleshooting aid. D-90