TM-9-1290-365-24&P Technical and Parts Manual for Paladin Muzzle Velocity System M93 Upgraded Download
Page 243 of 334
ARMY TM 9-1290-365-24&P Table D-12. Power Supply Module Test Data Sheet SER. NO. OF MODULE:_______ VOLTAGE OF MODULE:_______ Para. Min Result Actual Results Max. Result Pass/Fail Remarks D.6.11.3.1c. +4.9Vdc +5.1Vdc D.6.11.3.1d. O 5OmVp-p D.6.11.3.1e. 650mA 1050mA D.6.11.3.2c. V-0.lVdc V+0.1Vdc D.6.11.3.2d. O 5OmVp-p D.6.11.3.2e 1lOOmA l700mA D.6.11.3.2.f -0.1Vdc +0.1Vdc D.6.11.3.3b. +14.8Vdc 15.2Vdc D.6.11.3.3c. O 50mVp-p D.6.11.3.4b. -15.2Vdc -14.8Vdc D.6.11.3.4c. O 50mVp-p D.6.11.3.5b. +17.8Vdc 18.2Vdc D.6.11.3.5c. O 5OmVp-p D.6.11.3.6a. -0.1Vdc +0.1Vdc D.6.11.3.6b. +4Vdc +6Vdc D.6.11.3.7a 0.7Vdc 1.3Vdc D.6.11.3.7e. -0.1Vdc +0.1Vdc D6.11.3.8b +4.9Vdc +5.1Vdc D.6.11.3.8d. 14Vdc 16Vdc D.6.11.3.8g 15Vdc 17Vdc D.6.11.3.9b. -0.lmA +0.1mA D.6.11.3.9d. +4.9Vdc +5.1Vdc Date: ___________________________ Tested by: ___________________________ Inspected by: ___________________________ D.6.11.4 ADJUSTMENT PROCEDURE . D.6.11.4.1 PREPARATION FOR TEST . The test is conducted on a disassembled UUT. The test setup is shown in Figure D-29. Figures D-27. and D-28. are detailed illustrations of the special testers. a. Remove the UUT from higher assembly lAW para. D.4.6.7. b. Using soldering iron, remove resistors R16 and R17 from the CCA. c. Energize and adjust DMM1 to measure resistance. d. Connect DMM1 to points TP1 and TP2 on the text fixture, and adjust PR1 potentiometer to 17.5KOhm. e. Adjust DMM1 to measure DC volts. f. Energize and adjust DMM2 to measure high DC current (l0 Amp). D-73