TM-9-1290-365-24&P Technical and Parts Manual for Paladin Muzzle Velocity System M93 Upgraded Download
Page 206 of 334
ARMY TM 9-1290-365-24&P D.4.1 2.2.7 Integrated Simulator Test (versions AY6707292-4 and AY6707292-5 only). Refer to para. D.4.13.5 for troubleshooting procedures. a. Turn POWER, RF CONTROL, SD. ANT switches on the test fixture to OFF. Deenergize power supplies PS1, PS2. b. Reinstall the RF cable lAW para. D.4.11.7. c. Set function generator output function to square wave 50±1KHz, 5 ± 0.1Vp-p at the function generator output. d. Connect function generator to INT.SIM input on test fixture. e. Energize power supplies PS1, PS2. Disconnect the RMS voltmeter from the test fixture. Connect both channels of the oscilloscope to the VIDEO[+] and VIDEO[-] output on the test fixture. g. Point the antenna radiating surface towards free space. Set S.D. ANT. and POWER switches on the test fixture to ON. Set PIN SW DR V/INTERNAL SIM switch to INTERNAL SIM position. h. Verify the signal voltage level on CH1: VSAT[-] = 8Vp-p minimum. i. Verify the signal voltage level on CH2: VSAT[-] = 8Vp-p minimum. D.4.1 2.2.8 Set S. D.ANT and POWER switches to OFF. Deenergize power supplies PS1, PS2. Discon- nect the transceiver from the test fixture. END OF RF SECTION TEST. Table D-5. Transceiver Assembly RF Section Test Data Sheet TRANSCEIVER ASSEMBLY SER NO.___________ Para. Minimum Results Actual Results Maximum Results Pass/Fail Remarks D.4.12.2.3d. 200mA 600mA D.4.12.2.3e. +4.9Vdc +5.1Vdc D.4.12.2.3f. +14.8Vdc +i5.2Vdc D.4.12.2.3g. -15.2Vdc -14.8Vdc D.4.12.2.3i. 500mA 900mA D.4.12.2.3k 700mA 1100mA D.4.12.2.3m. 300mA 700mA D.4.12.2.4.f. 10524MHz 1052GM Hz D.4.12.2.5c. 1.0mW 3.0 mW D.4.12.2.5d. 20.8dBm 23.8dBm D.4.12.2.6.d. Broad band noise, no oscillation D.4.12.2.6b.(5) 1 00mV 300mv D.4.12.2.6b.(7) 100mV 300mv D.4.12.2.6.c. 50KHz sensitivity test D.4.12,2,6.c(2) 2.2.6c. (2) 13Vp-p D.4.12.6.C.(3) 13Vp-p D.4.12.2.6c.(7) RMS noise level (dBm) = D.4.12.2.6c.(8) RMS signal (dBm) = D-36