TM-9-1290-365-24&P Technical and Parts Manual for Paladin Muzzle Velocity System M93 Upgraded Download
Page 196 of 334
ARMY TM 9-1290-365-24&P D.4.11.6 INSTALLATION OF TRANSCEIVER . Refer to Figures D-1, D-2, and D-3. CAUTION Detector output pin must be grounded at all times. a. Using soldering iron, connect three wires to the oscillator input pin and ground lug. b. Using soldering iron, connect one wire to detector output pin, and two wires to the ground lug. Do not remove shorting wire during soldering. c. Disconnect the shorting wire from detector output pin. First disconnect from the pin, and then from ground lug. d. Place transceiver (5) into transceiver assembly (1). e. Install and fasten six screws (6), six lock washers (7), and six flat washers (8) which attach the transceiver (5) to the antenna base. f. Install RF cable (4) lAW para. D.4.11.7. D.4.11.7 INSTALLATION OF RF CABLE. D.4.11.7.1 Configuration AY6707292-3 and AY6707292-4 Refer to Figures D-1, D-2, and D-4. a. Place clamp (45) on RF cable (4). b. Install RF cable (4) to its position on the transceiver assembly (1). c. Hand tighten two SMA connectors of RF cable (4) to transceiver (5) and antenna connector. d. Fasten two SMA connectors of the RF cable (4) using a 5/16” hex wrench. e. Install and fasten screw (46), lock washer (47), and flat washer (48) which hold clamp (45) D.4.11.7.2 Configuration AY6707292-5. Refer to Figures D-3 and D-4. a. Install RF cable (4) into its groove on the transceiver assembly (1). b. Hand tighten two SMA connectors of RF cable (4) to transceiver (5) and antenna connector, while pressing the RF cable into its groove. c. Fasten two SMA connectors of the RF cable (4) using a 5/16” hex wrench. D.4.11.8 INSTALLATION OF INTEGRATED SIMULATION ASSEMBLY . Refer to Figures D-2. and D-3. Applies to configurations AY6707292-4 and AY6707292-5 only. a. Using crimping tool, crimp socket pin to wire B of integrated simulation assembly (49). NOTE b. Using insertion tool, insert wire B into connector P4 (26), pin 16. c. Place new solder sleeve on wires that connected to connector P4 (26), pin 8. Refer to Figure FO- 21. Shrink solder sleeve using heat gun. d. Install integrated simulator assembly (49) into transceiver assembly (1). Note the position marking on the integrated simulation assembly body. e. Install and fasten three screws (50) and three flat washers (51). D.4.11.9 REASSEMBLY OF TRANSCEIVER ASSEMBLY . Refer to Figures D-1, D-2. and D-3. a. Attach the two halves of the transceiver assembly (1) to each other. b. Fasten six hex captive screws (2). D-26 Change 1