TM-9-1290-365-24&P Technical and Parts Manual for Paladin Muzzle Velocity System M93 Upgraded Download
Page 195 of 334
ARMY TM 9-1290-365-24&P D.4.11.2 INSTALLATION OF MVP CCA . D.4.11.2.1 Configuration AY6707292-3 and AY6707292-4 Refer to Figures D-1. and D-2. a. Place MVP CCA (25) into transceiver assembly (1). b. Install and fasten 11 screws (28) and 11 flat washers (29) onto MVP CCA (25). c. Install and fasten three screws (30) and three flat washers (31) onto MVP CCA (25). d. Plug connector (26) into plug P1 of MVP CCA (25) and secure the connector by fastening the two locks. e. Plug connector (27) into plug P3 of MVP CCA (25) and secure the connector by fastening the two locks. D.4.11.2.2 Configuration AY6707292-5. Refer to Figure D-3. a. Place MVP CCA (25) into transceiver assembly (1). b. Install and fasten 14 screws (28) and 14 flat washers (29) onto MVP CCA (25). c. Plug connector (26) into plug P1 of MVP CCA (25) and secure the connector by fastening the two locks. d. Plug connector (27) into plug P3 of MVP CCA (25) and secure the connector by fastening the two locks. D.4.11.3 INSTALLATION OF POWER SUPPLY MODULE . Refer to Figures D-1, D-2, and D-3. Make sure to match oscillator operating voltage with power supply module output voltage. a. Place module (14) into transceiver assembly (1). b. Install and fasten eight screws (21), eight lock washers (22), and eight flat washers (23) onto module (14). c. Plug connectors (19,20) to the module (14), and secure by fastening four screw locks (18). D.4.11.4 INSTALLATION OF DOPPLER AMPLIFIER CCA . Refer to Figures D-1, D-2. and D-3. a. Place CCA (10) into transceiver assembly (1). b. Install and fasten 12 screws (15), 12 lock washers (16), and 12 flat washers (17) onto CCA (10). c. Using soldering iron, connect six wires to CCA (10). d. Remove identification tags from wires. e. Attach CCA cover (9) with eight screws (11), eight lock washers (12), and eight flat washers (13). D.4.11.5 INSTALLATION OF GASKET . Refer to Figures D-1, D-2, and D-3. CAUTION WARNING Use Methylethylketone (MEK) in a well ventilated area. Avoid breathing vapors. Keep away from flame. a. Clean and remove all residue of RTV from transceiver assembly housing. Use an acid brush moistened in MEK solvent. b. Remove the adhesive protection tape from the gasket and place gasket (24) on housing using sufficient pressure. Change 1 D-25