TM-9-1290-365-24&P Technical and Parts Manual for Paladin Muzzle Velocity System M93 Upgraded Download
Page 179 of 334
ARMY TM 9-1290-365-24&P Table D-2. Test Equipment and Special Tools Required (Cont) Nomenclature Part/Spec. No. Figure SMA Female/SMA Female Adapter Midwest Microwave, 2595 C-11, 31 N-Type Female/SMA Male Adapter Midwest Microwave, 2682 C-11, 32 ESD Work Station Kit M87893-02 C-11, 13 D.4.3 Materials Required. Repair materials and other consumable items required are listed in Table Table D-3. Materials Required Nomenclature Part/Spec. No. Appendix F Item No. Paint Color No.383 lAW FED-STD-595 CARC 21 Adhesive MIL-A-46146, Type III 19 Insulation Compound MIL-l-46058 TYPE 1B31 9 Solder SN63WRMAP3 23 Lacing Tape MIL-T-43435-B3/BLK 11 Solder Sleeve M8351 9/1-2 28 Bus Wire QQ-W-343/S-22-S1 T 13 Sealing Compound 83-31 16 Primer 747-55 17 Adhesive S1125 2 Adhesive RTV732 29 Acetone 0A51 1 Lockwire M520995-C22 30 Methylethylketone ASTM-D-740 14 Antistatic Bag 3271576 31 D.4.4 General Repair Requirements. The following general requirements apply to repair of the transceiver assembly: a. GENERAL . The transceiver does not contain high voltages or hazardous material. The transceiver radiates low-power X-band microwave energy, therefore RE safety precautions should be taken. b. RF-SAFETY . The transceiver radiates microwave energy at approximately 1 mW/cm 2 power density at the antenna surface. Maximum safe level is 10 mW/cm 2 lAW safety level of electromagnetic radiation with respect to personnel. The radar output field does not exceed the safety levels required by ANSI C95.1 - 1982, hazard for humans, by electromagnetic fields at normal or malfunction operation conditions. The transceiver output power is less than 220 mW, which is at any time three orders of magnitude below the requirements of MIL-STD-1358B. Although transmitted power density is less than the safety level, comply with the following warning when the transceiver is transmitting: Change 1 D-9