TM-9-1290-262-24&P Technical Manual for M2A2 Aiming Circle Download
Page 20 of 192
ARMY TM 9-1290-262-24&P MARINE CORPS TM 00476C-24&P AIR FORCE TO 49A7-3-72/74 2-3. PMCS PROCEDURES (cont). c. Item to be checked or serviced column. This column identifies the item to be checked or serviced. d. Procedure column. This column gives the procedure you must do to check or service the item listed in the Item to be Checked or Serviced column to know if the equipment is ready or available for its intended mission or for operation. You must do the procedure at the time stated in the inteval column. e. Not Fully Mission Capable If: column. Information in this column tells you what faults will keep your equipment from being capable of performing its primary mission. If check and service pro- cedures reveal faults listed in this column, do not operate the equipment. Follow standard operating procedures for maintaining the equipment or reporting equipment failure. Table 2-2. UNIT PREVENTIVE MAINTENANCE CHECKS AND SERVICES Not Fully Item Item to be Mission Capable No. Interval Checked or Serviced Procedure If: 1 Monthly M2A2 Aiming Check for deterioration or other dam- Circle age affecting proper seal. Tighten loose screws and nuts. Purge elbow telescope if optical sys- tem shows signs of fogging or traces of humidity. Refer to TM 750-116. Section Ill. UNIT TROUBLESHOOTING Section Index Paragraph 2-4. Troubleshooting Page Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-4 2-4. TROUBLESHOOTING INFORMATION. a. The symptom index can be used as a quick guide to troubleshooting. Common malfunctions are listed in alphabetical order, under each major assembly which appears in MAC order, with page number references to the troubleshooting table where a test or inspection and corrective action are provided. b. There is no unit level troubleshooting on the M2A2 Aiming Circle. The table lists the common malfunctions which you may find during the operation or maintenance of the M51 Instrument Light. You should perform the tests/inspections and corrective actions in the order listed. 2-4