TM-9-2920-225-34 HMMWV Generator Direct Support & General Support Maintenance Manual Download
Page 41 of 263
TM 9-2920-225-34 2-6. ROTOR, STATOR, AND DRIVE END BELL ASSEMBLY. TOOLS : No special tools required SUPPLIES : Artillery and automotive grease, type GAA, MIL-G-10924 Solvent, dry cleaning, type II (SD-2) Fed. Spec P-D-680 Felt, 1/8-inch thick Masking tape, PPP-T-42C PERSONNEL: One EQUIPMENT CONDITION : Generator removed from vehicle, pulley removed from generator. a. Preliminary Procedures. (1) Remove regulator assembly. Refer to para 2-3. (2) Remove end housing and insulator. Refer to para 2-4. (3) Remove intermediate housing. Refer to para 2-5. b. Disassembly. CAUTION Be careful when taking apart rotor, stator, and drive end bell assembly. If any part is damaged, generator is nonrepairable. FRAME 1 1. Take off nut (1), washer (2), and woodruff key (3) from shaft (4) of fan and rotor assembly. GO TO FRAME 2 I 2-25