TM-9-2920-225-34 HMMWV Generator Direct Support & General Support Maintenance Manual Download
Page 214 of 263
TM 9-2920-225-34 g. Assembly. FRAME 1 1. 2. 3. 4. 5. 6. 7. 8. 9. Put preformed packing (1) in bearing bore of end housing (2). Press lip seal (3) into rotor side of end housing (2) with smooth side of seal facing away from housing. Coat outer edge of seal with sealant. Place end housing (2) on short end of rotor shaft (4). Slide spacer (5) over shaft (4) with counterbore facing away from rotor (6). Put a light coating of grease around spacer and seal (3). Put preforming packing (7) over shaft (4) into spacer (5). Press bearing (8) onto shaft (4) into end housing (2). Make sure to hold up both rotor (6) and end housing. Fill cavity behind bearing (8) with grease. Put preformed packing (7) into spacer (5) and slide spacer onto shaft (4) with counterbore facing rotor (6). Put lip seal (3) into end housing (2) with smooth side of seal facing outward. Coat outer edge of seal with sealant. END OF TASK TA 103694 2-198