TM-9-2920-225-34 HMMWV Generator Direct Support & General Support Maintenance Manual Download
Page 208 of 263
1. 2. 3. 4. 5. 6. 7. NOTE If rotor (1) is not within limits given in table 2-10, generator is nonrepairable. Measure outside diameter of shaft (2) at end housing. Measure outside diameter of sliprings (3). Measure outside diameter of drive end bearing seat (4). Measure outside diameter of drive end of shaft (5), NOTE If end housing (6) is not within limits given in table 2-10, generator is nonrepairable. Measure inside diameter of end housing bearing bore ( 7). NOTE If bearing (8) is not within limits given in table 2-10, get a new bearing. Measure bearing (8) inside diameter (9). Measure bearing (8) outside diameter ( 10). GO TO FRAME 2 NOTE: CHECK ONLY THOSE PARTS WHICH o 10 ARE CALLED OUT IN THIS FRAME. PARTS WITHOUT CALLOUTS ARE SHOWN ONLY FOR REFERENCE PURPOSES OR ARE CHECKED IN ANOTHER FRAME. TA 103688 2-192