Covering the politics, Business and technology of defense - Subscribe Today

TM-9-2920-225-34 HMMWV Generator Direct Support & General Support Maintenance Manual Download

Page 187 of 263

TM 9-2920-225-34 2-19. DRIVE END BELL AND ROTOR ASSEMBLY. TOOLS: No special tools required SUPPLIES: None PERSONNEL: One EQUIPMENT CONDITION : Generator removed from vehicle, pulley removed from generator. a. Preliminary Procedures. (1) Clean outside of generator before disassembly. Refer to para 1-3. (2) Remove fan and hub assembly. Refer to para 2-17. (3) Remove slipring end housing. Refer to para 2-18. b. Removal. (1) Models 5504AA and 5504AB. FRAME 1 I 1. Straighten tabs on six locking plates (1). Take out 12 screws (2) and lockwashers (3) and six locking plates. 2. Take off coupling cover (4). Pull out driveshaft (5) and take two drive blocks (6) from block holder (7). 3. Take retaining ring (8) from rotor shaft (9) and take off block holder (7). GO TO FRAME 2 TA 103670 I 2-171