TM-9-2920-225-34 HMMWV Generator Direct Support & General Support Maintenance Manual Download
Page 141 of 263
TM 9-2920-225-34 e. Inspection and Repair. Refer to para 2-12e. f. Assembly. 1. 2. 3. 4. Put seal (1) into bearing bore in housing (2) with smooth side of seal facing away from bearing ( 3). Make sure that seal is flush with rear edge of bearing bore. Fill cavity behind seal (1) with grease. NOTE Have machine shop make installing tool. See figure 2-6. Place installing tool into seal (1) seal face rear of end bell. Place drive end bell (2) on shaft drive end bell. GO TO FRAME 2 from front of drive end bell (2) so lips of of rotor (4) so shaft forces tool out of w TA 103625 2-125