TM-9-2920-225-34 HMMWV Generator Direct Support & General Support Maintenance Manual Download
Page 139 of 263
TM 9-2920-225-34 1. Take out six screws and flat washers (1) from drive end bell (2). CAUTION When drive end bell (2) has been taken off, stator windings will show. Be careful not to nick or cause other damage to stator windings. Do not rest gen- erator on windings. NOTE Brushes will fall out of brush holders when drive end bell (2) is taken out. Take out brushes and check that they are not worn. Refer to para 2- 13d for in- spection procedures. 2. Pull drive end bell (2) and rotor (3) assembly from housing (4). END OF TASK TA 103623 I 2-123