TM-9-2815-237-34 HMMWV Engine Direct Support & General Support Maintenance Manual Download

Page 136 of 272

TM 9-2815-237-34 2-32. FUEL INJECTION PUMP REPAIR (Cont’d) 43. Align timing mark (11) on drive shaft (5) and timing mark (6) on rotor (7). 44. Apply light coat of seal lubricant to inside edge of housing (12). 45. Rotate cam ring (9) so index mark (11) is aligned with timing cover access hole (13). CAUTION Hydraulic head must only be installed far enough to install head locking screws, or leakage and damage to hydraulic head O-ring seal will result. 46. Install hydraulic head (10) in housing (12) with slight rotary motion. 47. Rotate head (10) and align head locking capscrew holes with holes in housing (12). 48. Install two head locking capscrews (8) finger tight. 2-115