TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 96 of 1555
TM 9-2320-387-24-2 Change 1 10-79 10-47. THREE POINT SEATBELT MAINTENANCE (Cont'd) 1. Install retractor (26) on lower bracket (27) with washer (25) and capscrew (24). Tighten capscrew (24) to 43-60 lb-ft (58-81 N•m). NOTE Perform steps 2 and 3 for M1114 models only. 2. Install bracket (4), padding (5), and D-ring (6) on upper support (3) with washer (7), screw (8), washer (2), and locknut (1). Tighten screw (8) to 37 lb-ft (50 N•m). 3. Install clamp (11) and saddle block (10) on upper support (3) with two washers (9.1) and screws (9). Tighten screws (9) to 35 lb-in. (4 N•m). NOTE Perform step 4 for M1113 models only. 4. Install washer (14) and D-ring (13) on padding (15) with capscrew (12). Tighten capscrew (12) to 35-40 lb-ft (47-54 N•m). 5. Install washer (17) and connector assembly (18) on bracket (16) with capscrew (19). Tighten capscrew (19) to 35-40 lb-ft (47-54 N•m). 6. Install washer (22) and buckle assembly (21) on body (23) with capscrew (20). Tighten capscrew (20) to 35-40 lb-ft (47-54 N•m). c. Front Seatbelt Installation M1114 VEHICLES 22 21 20 ~ 23 19 24 25 26 12 13 14 15 ~ ~ 27 16 17 18 1 2 3 4 5 6 7 8 9 9.1 10 11