TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 905 of 1555
25-13.3. RIGHT FRONT UNDERBODY ARMOR INSTALLATION (Cont’d) TM 9-2320-387-24-2 Change 1 25-36.29 11. Remove five locknuts (17) and capscrews (11) from right front underbody armor (1) and passenger side footwell upper armor (18). 12. Remove six socket-head screws (12) and three retainer plates (10) from right front underbody armor (1). 13. Remove two capscrews (22), washers (23), and spacers (21) from inner and outer holes in right front underbody armor (1) and right rear underbody (24). 14. Remove three locknuts (5) and capscrews (7) from right front underbody armor (1) and passenger side footwell outer armor (3). 15. Remove two socket-head screws (19) from front and rear holes in right front underbody armor (1) and vehicle side panel (20). 16. Remove four capscrews (16), washers (15), and resilient mount shim (13) from resilient mount (14) and right front underbody (1). 17. Using hydraulic jack, slowly lower right front underbody armor (1) and remove from underneath vehicle. 18. Enlarge twelve holes in left front underbody armor hat section (9) to 17/32-in. (13.5-mm) diameter. 19. Install twelve AVK fasteners (8) into right underbody armor hat section (9). 24 1 8 10 11 12 15 16 17 18 7 19 23 19 22 21 13 3 5 14 9 ENLARGE HOLES TO 17/32 IN. (13.5 MM) DIAMETER (5 PLACES) PLACE JACK HERE 20 ~