TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 900 of 1555
25-13.3. RIGHT FRONT UNDERBODY ARMOR INSTALLATION (Cont’d) TM 9-2320-387-24-2 25-36.24 Change 1 1. Apply sealing compound to threads of eight capscrews (4), and install passenger side footwell inner armor (7) on inner cowl (2) with capscrews (4). Tighten capscrews (4) to 23 lb-ft (31 N•m). 2. Install inner/outer cowl reinforcement (9) on inner cowl (2) with two capscrews (5) and locknuts (1). Tighten capscrews (5) to 35 lb-ft (47 N•m). 3. Match-drill nine 13/32-in. (10.3-mm) diameter holes from passenger side footwell inner armor (7) through inner/outer cowl reinforcement (9). 4. Install nine capscrews (6) and locknuts (8) through passenger side footwell inner armor (7) and inner/outer cowl reinforcement (9). Tighten capscrews (6) to 35 lb-ft (47 N•m). NOTE Step 5 removes the temporary mounting hardware installed in Step a. 5. Remove two nuts (12), washers (10), capscrews (11), and washers (10) from passenger side footwell upper armor (3). c. New Passenger Side Footwell Inner Armor and Inner/Outer Cowl Reinforcement Installation