TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download

Page 894 of 1555

TM 9-2320-387-24-2 25-36.18 Change 1 25-13.2. 10,500 LB HYDRAULIC WINCH REPAIR (Cont'd) 26. Apply hydraulic fluid to two O-rings (8) and install in ports (16) of motor (7). CAUTION Do not allow restrictor valve assembly to separate from valve and solenoid assembly during installation. Damage to parts may result. 27. Install restrictor (2), O-ring (3), and restrictor washer (4) into port (5) of valve and solenoid assembly (1). Secure restrictor (2), O-ring (3), and restrictor washer (4) with rubber band (6) on valve and solenoid assembly (1). 28. Apply adhesive to threads of four socket-head screws (9) loosely install two socket-head screws (9) then remove rubber band (6) being careful not to allow restrictor valve assembly (2), (3), and (4) to fall out of position in valve and solenoid assembly (1). 29. Install two remaining socket-head screws (9). Tighten socket-head screws (9) to 18 lb-ft (24 N·m). NOTE Valve and solenoid assembly is stamped with letter "P" at inlet port and with letter "T" at outlet port. 30. Using two copper washers (14) and banjo screw (13) install inlet banjo tube (15) to port "P" on valve and solenoid assembly (1). 31. Using two copper washers (10) and banjo screw (11) install outlet banjo tube (12) to port "T" on valve and solenoid assembly (1). 32. Tighten banjo screws (11) and (13) to 33-40 lb-ft (45-54 N·m). 2 1 1 3 4 5 5 6