TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 889 of 1555
TM 9-2320-387-24-2 Change 1 25-36.13 25-13.2. 10,500 LB HYDRAULIC WINCH REPAIR (Cont'd) 6. Apply hydraulic fluid to O-ring (17) and install into hole (18) of gear box/drum support (14). 7. Apply hydraulic fluid to O-ring (21) and install into hole (22) of gear box/drum support (14). 8. Apply grease to needle bearings (25) and shaft (24) of drive shaft plunger (26). NOTE The drive shaft assembly may be used to depress drive shaft plunger and drive shaft plunger spring to aid assembly. 9. Place drive shaft plunger spring (23) onto drive shaft plunger (26) (with smaller diameter of spring towards drive shaft plunger) and install into hole (22) of gear box/drum support (14). Depress drive shaft plunger (26) and drive shaft plunger spring (23) and install high lever (20) and lever pin (19). 10. Apply grease to shaft (28) of low lever plunger (27). 11. Place low lever spring (29) onto low lever plunger (27) and install into hole (18) of gear box/drum support (14). Depress low lever plunger (27) and low lever spring (29) and install low lever (16) and lever pin (15). 15 14 16 17 18 19 20 21 22 23 24 25 26 27 28 29