TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 878 of 1555
TM 9-2320-387-24-2 25-36.2 Change 1 25-13.2. 10,500 LB HYDRAULIC WINCH REPAIR , NOTE Tag hydraulic lines for assembly 1. Remove banjo screw (8), two copper washers (9), and inlet banjo tube (10) from valve and solenoid assembly (3). Discard copper washers (9). 2. Remove banjo screw (6), two copper washers (5), and outlet banjo tube (7) from valve and solenoid assembly (3). Discard copper washers (5). NOTE Restrictor, restrictor washer, and O-ring may come out of valve and solenoid assembly during removal. Be careful to catch parts during disassembly. 3. Remove four socket-head screws (4) and valve and solenoid assembly (3) from motor (1). 4. Remove two O-rings (2) from motor (1). Discard O-rings (2). 5. Remove restrictor (11), restrictor washer (13), and O-ring (12) from valve and solenoid assembly (3). a. Disassembly Tools General mechanics tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts Four copper washers (Appendix G, Item 24.1) Two O-rings (Appendix G, Item 293.1) O-ring (Appendix G, Item 293.2) Two O-rings (Appendix G, Item 293.3) O-ring (Appendix G, Item 293.4) Two O-rings (Appendix G, Item 293.5) Grease (Appendix C, Item 33) Adhesive (Appendix C, Item 3.1) Hydraulic fluid (Appendix C, Item 37) Manual References TM 9-2320-387-24P Equipment Condition Winch removed (M1113) (para. 12-27.1) Winch removed (M1114) (para. 12-36.1) Maintenance Level Direct Support This task covers: a. Disassembly c. Inspection b. Cleaning d. Assembly INITIAL SETUP: