TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download

Page 75 of 1555

TM 9-2320-387-24-2 Change 1 10-59 10-33. TUNNEL INTERIOR SIDE INSULATION REPLACEMENT This task covers: a. Removal b. Installation NOTE Replacement procedures for all tunnel interior side insulation are basically the same. This procedure covers the left front insulation. 1. Remove six screws (3), retainer rods (1), (2), (4), and insulation (6) from tunnel (5). NOTE Perform step 2 for M1114 models and step 3 for M1113 models. 2. Remove two screws (8) and washers (7) from insulation (6) and tunnel (5). 3. Remove four screws (9), two angle brackets (10), and insulation (6) from floor (11). NOTE Perform step 1 for M1113 models and step 2 for M1114 models. 1. Install insulation (6) and two angle brackets (10) on floor (11) with four screws (9). 2. Install insulation (6) on tunnel (5) with two washers (7) and screws (8). 3. Install insulation (6) and retainer rods (1), (2), and (4) on tunnel (5) with six screws (3). b. Installation a. Removal INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Manual References TM 9-2320-387-24P Equipment Condition • Left front cowl insulation removed (para. 10-31). • Gunner’s platform removed (M1114 only) (para. 11-71). • Rifle support removed (M1114 only) (para. 11-66). Maintenance Level Unit FOLLOW-ON TASKS: Install left front cowl insulation (para. 10-31). Install gunner’s platform (M1114 only) (para. 11-71). Install rifle support (M1114 only) (para. 11-66).