TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 733 of 1555
TM9-2320-387-24-2 18-6. ENGINE WIRING HARNESS REPLACEMENT (Cont’d) 1 22. Remove nut (211, lockwasher (20), clamp (221, and harness (19) from stud (18) on right front cylinder head (17). Discard lockwasher (20). 23. 24. Remove capscrew (271, lockwasher (261, washer (25), and clamp (24) from bracket (23) on right cylinder head (17). Discard lockwasher (26). Remove locknut (291, clamp (301, harness (191, and screw (28) from bracket (23) on right cylinder head (17). Discard locknut (29). 25. Remove nut and lo&washer assembly (43) and lead 3C (44) from body (42). Discard nut and lockwasher assembly (43). 26. Remove two capscrews (391, clamp (311, and harness (19) from body (42). 27. Remove nut (32), capscrew (331, clamp (341, and harness (19) from body (42). 28. Disconnect harness connector (35) from fan clutch. time delay (38). 29. Disconnect harness connector (36) from protective control box receptacle (37). 30. Disconnect body harness (41) from harness connector (40). 31. Remove harness (19) from body (42). NOTE Perform step 22 for Ml113 models. Perform steps 23 and 24 for Ml114 models. 18-39