TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 710 of 1555
TM 9-2320-387-24-2 I 18-4. STARTER REPAIR (Cont’d) I 1 I 16. 17. 18. 19. 20. 21. 22. Remove two nuts (12), lockwashers (ll), screws (8), washers (7), and two brush leads (10) from starter motor frame (4). Remove two brushes (9) from brush holder (6). Discard two lock- washers (11). Remove two screws (l), two brush leads (2), and brushes (13) from field coil (3) and brush holder (6). Remove four springs (5) from brush holder (6). Remove four nut and lockwasher assemblies (14), rubber washers (15), and cover (16) from studs of solenoid housing (18). Pull cover (16) away from solenoid housing (18) far enough to allow access to series winding lead (19) and screw (20). Discard rubber washers (15) and nut and lockwasher assemblies (14). Remove screw (20), washer (21), and series winding lead (19) from cover (16), and remove cover (16) and gasket (17) from solenoid housing (18). Discard gasket (17). Remove snapring (31), spring retainer (30), spring (29), spring retainer (28), rubber boot (32), and washer (33) from core shaft (27), and remove core shaft (27) from solenoid housing (18). Discard snapring (3 1). Hold core shaft (27) and remove locknut (26), washer (25), contact (24), spring (23), and washer (22) from core shaft (27). Discard locknut (26). 18-16