TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 706 of 1555
TM 9-2320-387-24-2 1 18-4. STARTER REPAIR I I I This task covers: a. Disassembly b. Cleaning c. Inspection d. Assembly e. Bench Testing and Adjustment INITIAL SETUP: Test Equipment Switch (Appendix B, Item 55) Multimeter (Appendix B, Item 155) Carbon pile (Appendix B, Item 52) Armature test set (Appendix B, Item 53) Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Pinion stop and snapring kit (Appendix G, Item 300) Thrust washer and spacer kit (Appendix G, Item 459) Gasket set (Appendix G, Item 101) Gasket set (Appendix G, Item 1031 Core parts kit (Appendix G, Item 26) Gasket kit, commutator end head (Appendix G, Item 1001 Materials/Parts (Cont’d) Two locknuts (Appendix G, Item 1641 Pinion O-ring (Appendix G, Item 2931 Washer kit (Appendix G, Item 468) Adhesive sealant (Appendix C, Item 13) Aircraft grease (Appendix C, Item 321 Lithium grease (Appendix C, Item 361 Lubricating oil (Appendix C, Item 49) Core shaft nut tool (Appendix D, Fig. 631 Manual References TM 9-2320-387-24P Equipment Condition Starter removed (para. 4-11). MaintenanceLevel Direct support a. Disassembly 1. Remove plug (4) and gasket (5) from pinion housing (3). Discard gasket (5). 2. Using core shaft nut tool, remove locknut (2) from end of core shaft (1) located inside pinion housing (3). Discard locknut (2). 18-12