TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download

Page 68 of 1555

TM 9-2320-387-24-2 1 1O-28. WINDSHIELD ASSEMBLY MAINTENANCE (Ml 113) This task covers: a. Removal b. Disassembly c. Assembly d. Installation INITIAL SETUP: Applicable Models Ml113 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Personnel Required One mechanic One assistant Manual References TM 9-2320-387-10 TM 9-2320-387-24P Equipment Condition l Soft top enclosure removed, if installed (TM 9-2320-387-10). l Windshield wiper arm pivot removed (para. 10-60). l Windshield retention bracket removed (para. 10-29). General Safety Instructions Windshield must be supported during removal and installation. hlaintenance Level Unit WARNING Windshield must be supported during removal and installation. Failure to support windshield may cause injury to personnel or damage to equipment. r-zzz-1 1. Remove five hitch pins (5) from hinge pins (6). 2. Remove five hinge pins (6) from upper hinge halves (2) and lower hinge halves (41. 3. Remove grommet (11) from A-pillar (12) and remove jumper harness (10). 4. Remove windshield assembly (1) from A-pillar (12). 5. Remove two seals (3) from windshield assembly (1). 6. Clean remains of seal (3) from windshield assembly (1). b. Disassembly 1. Remove thirteen screws (91, former (81, and seal (7) from windshield assembly (1). 2. Clean remains of seal (7) from windshield assembly (1). I] 1. Peel paper backing from seal (7) and install seal (7) on windshield assembly (1). 2. Install former (8) on seal (7) and windshield assembly (1) with thirteen screws (9). -1 1. Peel paper backing from two seals (3) and install seals (3) on windshield assembly (1). 2. Install windshield assembly (1) on A-pillar (12). 3. Install jumper harness (10) on windshield center pillar (13) and install grommet (11) on A-pillar (12). 4. Install upper hinge halves (2) on lower hinge halves (4) with five hinge pins (6). 5. Install five hitch pins (5) in hinge pins (6). 1o-52