TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 676 of 1555
TM 9-2320-387-24-2 16-8. FUEL INJECTION PUMP SHUTOFF SOLENOID MAINTENANCE This task covers: a. Removal b. Inspection c. Installation INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Three lockwashers (Appendix G, Item 1981 Locknut (Appendix G, Item 1601 Two fiber washers (Appendix G, Item 501 Manual References TM 9-2320-387-24P Equipment Condition Fuel injection pump cover removed (para. 16-71. Maintenance Level Direct support NOTE Working area should be clean, well-ventilated, and free from blowing dirt and dust. rxzzl 1. Remove terminal (51, washer (61, and shell (7) from stud (12). 2. Remove nut (81, lockwasher (91, washer (lo), and fiber washer (11) from stud (12). Discard lockwasher (9) and fiber washer (111. 3. Remove locknut (41, ground strap (3), lockwasher (21, nut (81, lockwasher (91, washer (lo), and fiber washer (11) from stud (14). Discard locknut (4), lockwashers (2) and (9), and fiber washer (11). 4. Remove electrical shutoff solenoid (13) from cover (11. I[ Inspect shell (7). Replace if cracked, deteriorated, or damaged. c. Installation 1. Install electrical shutoff solenoid (13) in cover (1). 2. Install fiber washer (111, washer (101, lockwasher (91, nut (81, lockwasher (2), ground strap (31, and locknut (4) on stud (14). 3. Install fiber washer (111, washer (lo), lockwasher (91, and nut (81 on stud (12). 4. Install shell (71, washer (61, and terminal (5) on stud (121. 16-16