TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 670 of 1555
TM 9-2320-387-24-2 i 6-6. FUEL INJECTION PUMP MAINTENANCE KonW NOTE Rotate engine in order to gain access to driven gear and injection pump retaining capscrews. 6. Remove three capscrews (9) from pump-driven gear and fuel injection pump (4). 7. Remove three nuts (51, washers (61, fuel injection pump (41, and gasket (1) from timing gear cover (7). Discard gasket (1). 8. Clean gasket surface of timing gear cover (7) and fuel injection pump (4). 1 b. Repair 1 For fuel injection pump repair procedures, notify general support (TM 9-2815-237-34). c. Installation 1. 2. 3. 4. 5. Align pin (2) on pump drive with elongated hole in pump-driven gear. Install gasket (11 and fuel injection pump (4) on timing gear cover (7). Align fuel injection pump timing marks (3) and gear cover timing marks (8). Install fuel injection pump (4) on timing gear cover (7) with three washers (6) and nuts (5). Secure pump-driven gear on fuel injection pump (4) with three capscrews (9). Tighten capscrews (9) to 13-20 lb-ft (18-27 N-m). 16-10