TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 621 of 1555
TM 9-2320-387-24-2 1527. ENGINE PREPARATION (Cont’d) 3. 4. 3. 6. 7. 8. Install wiring harness bracket (8) on oil pan (5) with two lockwashers (6) and nuts (7). Install left and right engine mount and insulator assemblies (9) on engine (4) with three lock- washers (10) and capscrews (11). Using 9/16-in. torque adapter, tighten capscrews (11) to 30-40 lb-ft (41-54 Nom). WARNING Starter must be supported during installation. Failure to support starter may cause injury to personnel or damage to equipment. Position shim(s) (12), if removed, and starter (13) on flywheel housing (20) with solenoid (14) facing outward. Slide front of starter (13) in bracket (17), ensuring bracket (17) is between washer (15) and starter (13). Apply thread-locking compound to capscrews (18). Install two washers (19) and capscrews (18) on starter (13) and engine (4). Tighten capscrews (18) to 30-40 lb-ft (41-54 N-m). Using crowfoot, tighten locknut (16) to 15-19 lb-ft (20-26 N-m). 15-89