TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 610 of 1555
TM 9-2320-387-24-2 15-27. ENGINE PREPARATION This taskcovers: a. Disassembly INITIAL SETUP: b. Assembly Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) SpecialTools Hex-head driver, &mm (Appendix B, Item 145) Torque adapter, g/X-in. (Appendix B, Item 133) Crowfoot, 9/16-in. (Appendix B, Item 139) Engine stand (Appendix B, Item 28) Materials/Parts Five lockwashers (Appendix G, Item 239) O-ring seal (Appendix G, Item 279) Six lo&washers (Appendix G, Item 205) Two lockwashers (Appendix G, Item 238) Six lockwashers (Appendix G, Item 217) Nut and lockwasher assembly (Appendix G, Item 245) Antiseize compound (Appendix C, Item 16) Rl’V sealant (Appendix C, Item 10) Materials/Parts (Cont’d) Sealing compound (Appendix C, Item 65) Sealing compound, thread-locking (Appendix C, Item 66) Manual References TM 9-2320-387-24P Equipment Condition Engine removed (para. 15-26). General Safetv Instructions l Direct personnel to stand clear during hoisting operation. l Starter must be supported during removal and installation. l Power steering pump must be supported during removal and installation. Maintenance Level Direct support WARNING Direct personnel to stand clear during hoisting operation. Failure to do this may cause injury to personnel. a. Disassembly 1. Place engine on stand and disconnect hoist. NOTE Have drainage container ready to catch oil. 2. Remove drainplug (5) and gasket (6) from oil pan (4). Allow oil to drain completely. 3. Install gasket (6) and drainplug (5) on oil pan (4). Tighten drainplug (5) to 20 lb-R (27 N-m). 4. Remove two capscrews (3) and sling bracket (7) from left cylinder head (8). ’ 5. Remove pin (2) from sling bracket (7) and engine lifting sling (1). 6. Remove two capscrews (9) and engine lifting sling (1) from right cylinder head (10). I 5-78