TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 542 of 1555
15-4. LEFT CYLINDER HEAD REPAIR (Cont’d) TM 9-2320-387-24-2 15-10 Change 1 c. Installation CAUTION Head gasket must be used without a sealer. Sealant may cause leaks or damage to engine. 1. Install head gasket (3) over dowel pins (5) on cylinder block (6). 2. Apply pipe sealing compound to threads and under heads of seventeen capscrews (2). CAUTION Failure to tighten cylinder head capscrews in proper torque sequence may result in leaks or damage to cylinder head. 3. Install cylinder head (1) on cylinder block (6) with seventeen capscrews (2). Tighten capscrews (2) to 20 lb-ft (27 N•m) following torque sequence. 4. Tighten seventeen capscrews (2) to 55 lb-ft (75 N•m) following torque sequence. 5. Retighten seventeen capscrews (2) to 55 lb-ft (75 N•m) following torque sequence shown. 6. Tighten seventeen capscrews (2) an additional 90° following torque sequence and mark capscrews (2). 7. Connect harness lead 33B (7) to engine temperature sending unit (4). 1 2 3 5 6 7 4