TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download

Page 538 of 1555

TM 9-2320-387-24-2 15-3. ENGINE MOUNT AND INSULATOR MAINTENANCE (Cont’d) 1. 2. 3. 4. 5. 6. 7. install engine mount (2) and insulator (9) on engine (3) with three lockwashers (4) and capsmews (5). Using 9/16-m torque adapter, tighten capscrews (5) to 30-40 lb-R (41-54 IV&. using cmvfbot and adapter, tighten nut (11) to 24 lb-R (33 N*m) on starter support bracket (1) and starter (10). Lower engine (3) until insulator (9) is aligned and resting on engine mount bracket (6). Install two washers (8) and locknuts (7) on insulator (9) and engine mount bracket (6). Using 3Wn. torque adapter, tighten locknuts (7) to 90 lb-R (122 N-m). Remove pm (12) from sling bracket (14) and engine hf%ing sling. Remove two capscrews (13) and sling bracket (14) from left cylinder head (15). Remove two capscrews (17) and engine lift sling f?om right cylinder head (16). Install two radiator supports (19) on airlift brackets (21) with four capscrews (201, washers (221, and locknuts (18). Tighten capscrews (20) to 37 lb-R (50 N=m).