TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download

Page 536 of 1555

TM 9-2320-387-24-2 I 15-3. ENGINE MOUNT AND INSULATOR MAINTENANCE (Cont’d) I NOTE l Install sling bracket on rear of engine first. l Use four 15x25-mm capscrews to instaIl Iifbing sling on engine. 5. Install engine Iitig sling on engine (2) and right cylinder head (7) with two capscrews (6). 6. InstalI sling bracket (4) on left cylinder head (5) with two capscrews (3). Tighten capscrews (6) and (3) and install bracket (4) on engine Iifting sling with pin (1). WARNING Direct ah personnel to stand clear during hoisting operation. Failure to do this may cause injury to personnel. 7. Attach hoist to engine lifting sling. Slowly raise engine (2) enough to remove engine mount (8) and insulator (10) from engine mount bracket (9). 8. Remove engine mount (8) and insulator (10) from engine mount bracket (9). b. Disassembly &move four locknuts (13), washers (12), capscrews (ll), washers (12), starter bracket (14) (for right mount), and insulator (10) from engine mount (8). Discard locknuts (13). InstaIl insulator (10) and starter bracket (14) (for right mount) on engine mount (8) with four washers (12), CEQSCEWS (ll), washers (12), and locknuts (13). Tighten locknuts (13) to 37 lb-R (50 N-m). ENGINE urnNG