TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 534 of 1555
TM 9-2320-387-24-2 15-3. ENGINE MOUNT AND INSULATOR MAINTENANCE This task covers: a. Removal b. Disassembly c. Assembly d. Installation INITIAL SETUP: Tools Manual References General mechanic’s tool kit: TM 9-2320-387-24P automotive (Appendix B, Item 1) Equipment Condition Special Tools l Fuel pump removed (right engine mount only) Crowfoot, 5/8-m (Appendix B, Item 1381 (para. 3-24). Torque adapter, 9/16-in. (Appendix B, Item 133) l Right engine splash shield removed (para. 10-24). Torque adapter, 314-m (Appendix B, Item 134) l Engine access cover removed (para. 10-22). Adapter, 3/8-1/2-m (Appendix B, Item 135) l Front propeller shaR removed (left engine Engine lifting sling (Appendix B, Item 24) mount only) (para. 6-2). Materials/Parts l Glow plug controller removed (para. 433). Three lo&washers (Appendix G, Item 1901 l Air horn support and engine lift bracket removed Eight locknuts (Appendix G, Item 156) (para. 3-16). Two locknuts (Appendix G, Item 121) General Safety Instructions Personnel Required Direct all personnel to stand clear during hoisting operation. One mechanic One assistant Maintenance Level Direct support pizzq NOTE Left and right engine mounts are removed basically the same. 1. Remove two locknuts (6) and washers (7) from insulator (81 on engine mount bracket (5). Discard locknuts (6). 2. Loosen nut (91 securing starter (10) to starter support bracket (11). 3. Remove three capscrews (4) and lockwashers (3) from right engine mount (1) and cylinder block (21. Discard lo&washers (3). 4. Remove four locknuts (161, washers (151, and capscrews (13) from two radiator supports (121 and airlift brackets (14). Discard locknuts (16). 15-2