TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 495 of 1555
12-39. AIR CLEANER SHIELD MAINTENANCE This task covers: a. Removal c. Installation b. Inspection a. Removal 1. Loosen clamp (3) and disconnect air horn-to-air cleaner elbow (4) from air cleaner assembly (6). 2. Disconnect air cleaner-to-selector valve vent line (2) from air cleaner assembly (6). 3. Disconnect air restriction gauge hose (5) from air cleaner assembly (6). 4. Loosen two clamps (7) from air cleaner assembly (6) and support brackets (9). 4.1. Remove three screws (1.2), washers (1.3), and air cleaner shield (1.1) from air induction box (1). 5. Remove air cleaner assembly (6) and gasket (8) from air induction box (1). INITIAL SETUP: Applicable Models M1113 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Manual References TM 9-2320-387-24P Equipment Condition Air intake assembly removed (para. 3-19). Maintenance Level Unit TM 9-2320-387-24-2 12-72 Change 1 b. Inspection Inspect gasket (8). Replace if broken or cracked. c. Installation 1. Install air cleaner assembly (6) and gasket (8) on air induction box (1) and support brackets (9) with two clamps (7). Tighten clamps (7) to 35-40 lb-in. (4-5 N•m). 2. Install air cleaner shield (1.1) on air induction box (1) with three washers (1.3) and screws (1.2). 3. Connect air restriction gauge hose (5) to air cleaner assembly (6). 4. Connect air cleaner-to-selector valve vent line (2) to air cleaner assembly (6). 5. Connect air horn-to-air cleaner elbow (4) to air cleaner assembly (6). Tighten clamp (3) to 45-50 lb-in. (5-6 N•m).