TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 476 of 1555
TM 9-2320-387-24-2 12-68.14 Change 1 12-36.4. 10,500 LB REAR HYDRAULIC WINCH HOSE REPLACEMENT (Cont'd) NOTE • Use tape on one hose for ease of installation and identification from rear winch to valve assembly port. • When positioning hoses on vehicle, place ends with heat shield closest to fittings at rear of vehicle. 1. Starting from left rear of vehicle (14), route two hydraulic hose assemblies (1) and (2) over rear crossmember (13), over differential support (12), and over muffler (11). 2. Route two hydraulic hose assemblies (1) and (2) between speedometer drive (15) and transfer case (16). Continue along right side of transmission shift linkage (10), next to transfer case cooler lines (9), and towards front of vehicle. 3. Route two hydraulic hose assemblies (1) and (2) along left inner cowl (6), two hydraulic hoses (7), and between body wiring harness (8) to port 2 adapter (3) and port 4 adapter (5) on valve assembly (4). 4. Connect hydraulic hose assembly (1) to port 2 adapter (3) on valve assembly (4). 5. Connect hydraulic hose assembly (2) to port 4 adapter (5) on valve assembly (4). b. Installation