TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 462 of 1555
TM 9-2320-387-24-2 I 12-36. REAR WINCH CLUTCH CABLE REPLACEMENT 1 This task covers: a. Removal b. Installation INITIAL SETUP: Applicable Models Ml114 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Manual References TM 9-2320-387-24P Maintenance Level Unit hlaterialearts Locknut (Appendix G, Item 160) 1 a. Removal ] 1. Remove locknut (61, washer (7), rod end (81, two washers (91, and capscrew (11) from lever (10). Discard locknut (6). 2. Loosen nut (5) and remove rod end (8) and nut (5) from cable (4). 3. Loosen nut (2) and remove handle (1) and nut (2) from cable (4). 4. Remove two clips (3) and cable (4) from bracket (12). b. Installation 1. Install cable (4) on bracket (12) with two clips (3). 2. Install nut (2) and handle (1) on cable (4). Tighten nut (2). 3. Install nut (5) and rod end 03) on cable (4) and adjust rod end (8) and nut (5) as required to allow full clutch operation. 4. Tighten nut (5). 5. Install capscrew (111, two washers (9), and rod end (8) on lever (10) with washer (7) and locknut (6). 12-68