TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 458 of 1555
TM 9-2320-387-24-2 12-33. REAR WINCH REPLACEMENT (Cont’d) I 3. Remove two retaining rings (21, shaft (41, and roller (31 from bracket (1). 4. Remove two retaining rings (5), shaft (7), and roller (6) from bracket (1). 5. Remove capscrew (22) and ground lead (21) from winch (101. 6. Remove locknut (141, washer (151, rod end (161, capscrew (131, and two washers (12) from lever (11). Discard locknut (14). 7. Disconnect vent line (9) from elbow (8). 8. Remove four capscrews (181, washers (17), and winch (10) from winch mount (19) and bracket (20). [I 1. 2. 3. 4. 5. 6. 7. 8. 9. Install winch (10) on winch mount (19) and bracket (20) with four washers (17) and capscrews (18). Tighten capscrews (18) to 60 lb-R (81 N-m). Install two washers (121, capscrew (131, and rod end (16) on lever (11) with washer (15) and locknut (14). Tighten locknut (14) to 44 lb-ft (60 N-m). Install ground lead (21) on winch (10) with capscrew (22). Tighten capscrew (22) to 25 lb-ft (34 N-m). Connect vent line (9) to elbow (8). Install roller (6) and shaft (7) on bracket (1) with two retaining rings (5). Install roller (3) and shaft (4) on bracket (1) with two retaining rings (2). Install cover (25) and control receptacle (23) on bracket (20) with four screws (24) and nuts (26). Connect power lead (28) to solenoid pack power stud (27) with nut (29). Apply RTV sealant on power lead (28) and stud (27). 12-64