TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 440 of 1555
TM 9-2320-387-24-2 12-31. FRONT WINCH CLUTCH ROD REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Applicable Models Ml113 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) MateriaWParts Locknut (Appendix G, Item 162) Manual References TM 9-2320-387-24P Maintenance Level unit 1 a. Removal 1 1. Remove locknut (91, washer (101, rod end (121, two washers (111, and capscrew (13) from lever (1). Discard locknut (9). 2. Remove rod end (12) from clutch rod (6). 3. Remove clutch rod (61 through bracket (7) and frame (2). 4. Loosen nut (5) and remove handle (4) and nut (5) from clutch rod (6). ’ 5. Remove capscrew (3) and bracket (7) from winch (8). b. Installation 1. Install bracket (7) on winch (8) with capscrew (3). 2. Install nut (5) and handle (4) on clutch rod (6). Tighten nut (5). 3. Install clutch rod (6) through frame (2) and bracket (71. 4. Install rod end (121 on clutch rod (6). NOTE Adjust rod end as required to allow full clutch operation. 5. Install capscrew (131, two washers (111, and rod end (121 on lever (1) with washer (10) and locknut (9). 12-60