TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 420 of 1555
12-25. POWER CABLE REPLACEMENT This task covers: a. Removal b. Installation a. Removal NOTE • Perform steps 1 and 2 for M1113 models only. • Perform steps 3 through 5 for M1114 models only. 1. Remove nut (5), lockwasher (4), washer (3), and positive lead (2) from power feed-through stud (10). Discard lockwasher (4). 2. Remove nut (6), lockwasher (7), and negative lead (8) from shunt stud (9). Discard lockwasher (7). 3. Loosen terminal lugs (12) and remove cover (11) from terminal board (21). 4. Remove two nuts (13), lockwashers (14), washers (15), power cable leads (17), and cable leads (16) and (22) from terminal board (21). 5. Remove screw (20), clamp (19), and power cable (1) from support bracket (18). INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Four nut and lockwasher assemblies (Appendix G, Item 245) Two lockwashers (Appendix G, Item 217) Two tiedown straps (Appendix G, Item 462) Sealing compound (Appendix C, Item 70) Manual References TM 9-2320-387-24P Equipment Condition Battery ground cables disconnected (para. 4-68). Maintenance Level Unit TM 9-2320-387-24-2 Change 1 12-47 M1113 M1114 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 13 14 15 22 21 20 19 18 1 5 5