TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 355 of 1555
TM 9-2320-387-24-2 I-- 1 l-79. SHELTER SUPPORT ASSEMBLY REPLACEMENT I This task covers: a. Removal b. Installation INITIAL SETUP: Applicable Models Ml113 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts Locknut (Appendix G, Item 109) Sixteen locknuts (Appendix G, Item 134) Four locknuts (Appendix G, Item 184) Personnel Required One mechanic One assistant Manual References TM 9-2320-387-10 TM 9-2320-387-24P EquipmentCondition l Shelter carrier tailgate brackets removed (para. 11-74). l Fuel filler housing removed (para. 10-2). l Rear soft top curtain rolled up (TM 9-2320-387-10). l Shelter removed (para. 11-78). Maintenance Level Unit I a. Removal 1 1. 2. 3. 4. 5. 6. 7. 8. Remove two locknuts (24), washers (2), capscrews (4), washers (5), and spacers (6) from support assembly (27), cargo floor (22), and B-beam (26). Discard locknuts (24). Remove six locknuts (24), washers (2), reinforcement plates (23) and (25), six capscrews (3), washers (2), and spacers (1) from support assemb!y (27), cargo floor (22), and B-beam (26). Discard locknuts (24). Remove two locknuts (21), washers (7), capscrews (9), and washers (10) from support assembly WY and cargo floor (22). Discard locknuts (21). Remove locknut (34), washer (33), capscrew (29), and washer (30) from clamp (3‘2) on fuel filler spout (28) and body (31). Pull fuel filler spout (28) away for access to locknut (21). Discard locknut (34). Remove two locknuts (21), washers (7), capscrews (8), and washers (7) from support assembly (27) and cargo floor (22). Discard locknuts (21). Remove four locknuts (19), washers (14), capscrews (13), and washers (14) from support assembly (27 and cargo floor (22). Discard locknuts (19). Remove three locknuts (20), washers (15), capscrews (16), and washers (15) from support assembly (27), cargo floor (22), and D-beam (17). Discard locknuts (20). Remove locknut (18), washer (12), capscrew (ll), washer (12), and support assembly (27)from cargo floor (22) and D-beam (17). Discard locknut (18). b. Installation NOTE Do not tighten hardware until all hardware is installed. 1. Install support assembly (27) on cargo floor (22) and D-beam (17) with washer (12), capscrew (ll), washer (12), and locknut (18). 2. Install three washers (l5), capscrews (16), washers (15), and locknuts (20) on support assembly (27), cargo floor (22), and D-beam (17). 3. Install four washers (14), capscrews (13), washers (14), and locknuts (19) on support assembly (27) and cargo floor (22). 11-142