TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 353 of 1555
TM 9-2320-387-24-2 I 1 l-78. SHELTER REPLACEMENT I This taskcovers: a. Removal b. Installation INITIAL SETUP: ApplicableModels Ml113 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts Eight capscrews (Appendix G, Item 18) Eight lockwashers (Appendix G, Item 225) Personnel Required One mechanic One assistant Manual References TM 9-2320-387-10 TM 9-2320-387-24P Equipment Condition Tailgate lowered (TM 9-2320-387-10). General SafetyInstructions Direct all personnel to stand clear during hoisting operations. Maintenance Level Unit plYiizq WARNING Direct all personnel to stand clear during hoisting operations. A heavy, swinging load can cause injury to personnel and damage to equipment. 1. Position chain hoist (2) over top of shelter (3). 2. Connect lifting chains (1) to chain hoist (2) and four comers of shelter (3). NOTE l It may be necessary to detach cab rear panel straps and turnbuttons and roll cab rear panel upward to gain access to front mounting brackets. l Note number and location of shims prior to removal for installation. 3. Remove eight capscrews (12), lo&washers (111, washers (101, and four reinforcements (91 from mounting brackets (6) and support assembly (41, and remove shims (7), if present. Discard cap- screws (12) and lockwashers (11). 4. Using chain hoist (2), remove shelter (3) from support assembly (4). 5. Remove mounting brackets (6) (para. 11-76). Ib.lnstallationl WARNING Direct all personnel to stand clear during hoisting operations. A heavy, swinging load can cause injury to personnel and damage to equipment. 1. Install mounting brackets (para. 11-73). 2. Position shelter (3) over support assembly (4) and gradually lower shelter (3) into position on support assembly (4) with front mounting points (5) aligned. NOTE Shelter should be tightly fitted on front of support assemblyand centered fi-om side to side. Shims should only be added at rear shelter mounting brackets. 3. Install shelter (3) on front of support assembly (4) and two mounting brackets (6) with reinforcements (91, four washers (lo), lockwashers (111, and capscrews (12). Tighten capscrews (12) to 90 lb-R (122 N-m) and capscrews (8) to 60 lb-R (81 N-m). 1l-140