TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 333 of 1555
TM 9-2320-387-24-2 I 1 l-62. TURRET PINTLE MOU.NT MAINTENANCE This task covers: a. Removal b. Inspection c. Installation INITIAL SETUP: Applicable Models Ml114 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts RTV sealant (Appendix C, Item 74) Sealing compound (Appendix C, Item 64) Personnel Required One mechanic One assistant Manual References TM 9-2320-387-10 TM 9-2320-387-24P EquipmentCondition Turret hatch open (TM 9-2320-387-10X MaintenanceLevel Unit 1. Remove twelve capscrews (6) and washers (7) from turret armor (3) and turret pintle mount (1). 2. Remove capscrew (5) and washer (4) from turret armor (3) and turret pintle mount (1). 3. Remove turret pintle mount (1) from turret armor (3). 4. Remove four screws (9), pin assembly (81, and pintle brush seal (2) from turret pintle mount (1). b. Inspection Inspect pintle brush seal (2). Replace if damaged. vf.Installationl 1.. Install pintle brush seal (2) and pin assembly (8) on turret pintle mount (1) with four screws (9). Tighten screws (9) to 30 lb-in. (3 N-m). 2. Apply sealant to thirteen bosses (10) on bottom of pintle mount (1) and around holes in turret armor (3). 3. Install turret pintle mount (1) on turret armor (3) with washer (4) and capscrew (5). Do not tighten capscrew (5). NOTE Apply sealing compound to capscrews prior to installation. 4. Install twelve washers (7) and capscrews (6) on turret pintle mount (1) and turret armor (3). Tighten capscrews (6) and (5) to 37 lb-R (50 Nom). 1 l-120