TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 33 of 1555
TM 9-2320-387-24-2 10-18 Change 1 10-9. HOOD AND HINGE MAINTENANCE (Cont’d) FOLLOW-ON TASK: Lower and secure hood (TM 9-2320-387-10). 1 2 5 6 8 7 NOTE Spacing between A-pillar and hood should be no less than 1/2 in. (12.7 mm). 1. Lower hood (4) and check alignment of hood stop guide (3) with center hood stop (2) on A-pillar (1) and hood latch plate (5) with side hood stop (6). NOTE Upper and lower hinge halves contain slotted mounting holes to allow for adjustment. 2. With hood (4) lowered and secured, and alignment correct, tighten four locknuts (7) on lower hinge half (8) to 60 lb-ft (81 N • m). NOTE After hood alignment is completed, some contact may occur between hood and left mirror bracket. If contact exists, use file and trim about 1/4 in. (6.4 mm) off left corner and edge of hood. Trim until hood closes without hitting left mirror bracket. Touch up with paint (TM 43-0139). c. Alignment 3 4