TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 316 of 1555
INITIAL SETUP: Applicable Models M1114 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts RTV sealant (Appendix C, Item 74) Sealing compound (Appendix C, Item 64) Adhesive (Appendix C, Item 4) 11-52. TURRET ARMOR AND SEAL REPLACEMENT This task covers: a. Removal b. Installation 1. Remove seal (2) from turret armor (3). Thoroughly clean the edge of turret armor (3). NOTE Note location of mount holes for installation. 2. Remove two capscrews (1) and turret armor (3) from turret bearing (5). 1. Apply a 1/16-in. (1.6-mm) to 1/8-in. (3.2-mm) bead of adhesive to seal (2) lip. 2. Starting somewhere other than at a corner, press seal over lip of turret armor (3). 3. Allow seal (2) to set and cure undisturbed for about one hour. 4. Apply sealant around turret armor mount holes (4). 5. Apply sealing compound to capscrews (1). 6. Install turret armor (3) on turret bearing (5) with two capscrews (1). Tighten capscrews (1) to 37 lb-ft (50 N•m). b. Installation a. Removal Manual References TM 9-2320-387-24P Equipment Condition • Night vision mount removed (para. 11-60). • Turret pintle mount removed (para. 11-62). • Turret armor brush seal removed (para. 11-51), if required. • Turret door removed (para. 11-53), if required. • Turret armor hatch latch removed (para. 11-50). • Turret hatch pivot base removed (para. 11-59). Maintenance Level Unit TM 9-2320-387-24-2 Change 1 11-103 FOLLOW-ON TASKS: • Install turret hatch pivot base (para. 11-59). • Install turret armor hatch latch (para. 11-50). • Install turret door (para. 11-53), if removed. • Install turret armor brush seal (para. 11-51). • Install turret pintle mount (para. 11-62). • Install night vision mount (para. 11-60). 1 1 4 2 3 4 5