TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 292 of 1555
11-41. DRIVER’S FOOTWELL INNER ARMOR MAINTENANCE INITIAL SETUP: Applicable Models M1114 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts Six locknuts (Appendix G, Item 169) Sealing compound (Appendix C, Item 72.1) Personnel Required One mechanic One assistant Manual References TM 9-2320-387-24P Equipment Condition • Accelerator linkage removed (para. 3-43). • Steering wheel lock removed (para. 10-48). • Tunnel interior side insulation removed (para. 10-33). • Left front cowl insulation removed (para. 10-31). Maintenance Level Unit TM 9-2320-387-24-2 11-84 Change 1 NOTE If new driver’s footwell inner armor is installed, perform para 11-36.1. NOTE Note location of screws and spacers for installation. 1. Remove fifteen capscrews (7) from footwell armor (1), footwell (6.2), and left front underbody (6.1). 2. Remove six locknuts (5), capscrews (4), and spacers (3) from footwell armor (1) and footwell (6.2). Discard locknuts (5). 3. Remove six capscrews (2), washer (4.1), and footwell armor (1) from inner cowl (6). Refer to para. 10-56 for plusnut inspection and replacement. 1. Apply sealing compound to threads of six capscrews (2), and install footwell armor (1) on inner cowl (6) with capscrews (2) and washer (4.1). Tighten capscrews (2) to 23 lb-ft (31 N•m). NOTE Ensure large spacers are installed in upper holes. 2. Install six spacers (3), capscrews (4), and locknuts (5) on footwell armor (1) and footwell (6.2). Tighten locknuts (5) to 35 lb-ft (47 N•m). 3. Apply sealing compound to threads of fifteen capscrews (7), and install capscrews (7) on footwell armor (1), footwell (6.2), and left front underbody (6.1). Tighten capscrews (7) to 35 lb-ft (47 N•m). c. Installation b. Inspection a. Removal This task covers: a. Removal c. Installation b. Inspection