TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 27 of 1555
10-8. HOOD PROP ROD AND BRACKET MAINTENANCE TM 9-2320-387-24-2 10-12 Change 1 This task covers: a. Removal d. Assembly b. Disassembly e. Installation c. Inspection INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts Four lockwashers (Appendix G, Item 207) Locknut (Appendix G, Item 116) Cotter pin (Appendix G, Item 30) Manual References TM 9-2320-387-10 TM 9-2320-387-24P Equipment Condition Hood raised and secured (TM 9-2320-387-10). General Safety Instructions Hood must be supported during hood prop rod and bracket replacement. Maintenance Level Unit WARNING Hood must be supported during hood prop rod and bracket replace-ment. Failure to support hood may cause injury to person- nel or damage to equipment. 1. Remove cotter pin (4), washer (3), hood prop rod (2), and washer (3) from hood (1). Discard cotter pin (4). 2. Remove four screws (8), lockwashers (7), and bracket (6) from airlift bracket (5). Discard lock- washers (7). 1. Remove hood prop rod (2) from eyebolt (15). 2. Remove locknut (9), washer (10), bushing (16), spring (11), eyebolt (15), and washer (14) from bracket (6). Discard locknut (9). 3. Remove snapring (12) and bushing (13) from bracket (6). Inspect bushings (13) and (16) and spring (11) for cracks, wear, or distortion. Replace bushings (13) and (16) and spring (11) if cracked, worn, or distorted. 1. Install bushing (13) on bracket (6) with snapring (12). NOTE Length of spring with bracket assembled is 2-1/4 in. (5.7 cm). 2. Install washer (14), eyebolt (15), and spring (11) on bracket (6) with bushing (16), washer (10), and locknut (9). 3. Install hood prop rod (2) into eyebolt (15). d. Assembly c. Inspection b. Disassembly a. Removal