TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 22 of 1555
NOTE • If only rubber latch is to be replaced, spring pin does not have to be completely out of base. • M1114 vehicles are equipped with plusnuts/tapping blocks instead of nuts and washers. 1. Remove two locknuts (6), washers (4), capscrews (3), washers (4), and base (7) from body (5). Discard locknuts (6). 2. Remove spring pin (2) and latch (10) from base (7). Discard spring pin (2). Remove cotter pin (1), pin (8), two rollers (9), and hood latch (11) from latch (10). Discard cotter pin (1). b. Disassembly a. Removal TM 9-2320-387-24-2 Change 1 10-7 10-5. HOOD LATCH MAINTENANCE This task covers: a. Removal c. Assembly b. Disassembly d. Installation Manual References TM 9-2320-387-10 TM 9-2320-387-24P Equipment Condition Hood raised and secured (TM 9-2320-387-10). Maintenance Level Unit INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts Two locknuts (Appendix G, Item 109) Cotter pin (Appendix G, Item 29) Spring pin (Appendix G, Item 450) Sealing compound (Appendix C, Item 72.1) 1 2 3 4 5 4 6 7 8 9 10 11 9