TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 215 of 1555
WARNING Drycleaning solvent is highly flammable. Do not perform this pro- cedure near fire, flames, or sparks. Injury to personnel and/or damage to equipment will result. NOTE Use drycleaning solvent to remove adhesive from window chan- nels. 1. Remove three seals (2) from window channels (3). 2. Remove five seals (1) from window channels (3). 1. Apply a thin coat of adhesive on inside of window channel (3). NOTE Seal is supplied in bulk and must be cut to fit. 2. Trim three seals (2) to fit window channels (3), as required. NOTE Ensure mating surfaces of seals are installed on window channels evenly. 3. Apply a thin coat of adhesive on three seals (2) and install seals (2) on window channels (3). NOTE Two seals will be trimmed 21.25-in. (540 mm) in length, two seals will be 20.00-in. (508 mm) in length, and one seal will be 16.00-in. (406 mm) in length. 4. Trim five seals (1) to fit window channels (3), as required. NOTE Ensure mating surfaces of seals are installed on window channels evenly. 5. Apply a thin coat of adhesive on edges of window channels (3) and on contact edge of five door seals (1). NOTE Two seals are located on right side, two seals on left side, and one seal on top of window channels. 6. Install five seals (1) on window channels (3). b. Installation a. Removal 11-10. DOOR WINDOW SEAL REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Applicable Models M1114 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Seal (Appendix G, Item 377) Drycleaning solvent (Appendix C, Item 26) Adhesive (Appendix C, Item 4) Manual References TM 9-2320-387-24P Equipment Condition Door window removed (para. 11-3). General Safety Instructions Do not perform this procedure near fire, flames, or sparks. Maintenance Level Unit TM 9-2320-387-24-2 11-20 Change 1