TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 2 Download
Page 213 of 1555
TM 9-2320-387-24-2 11-9. DOOR LATCH ADJUSTMENT _ This task covers: a. Exterior Handle Adjustment b. Interior Handle Adjustment c. Locking Rod Adjustment INITIAL SETUP: Applicable Models Manual References Ml114 TM 9-2320-387-24P Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Equipment Condition Door latch cover removed (para. 11-6). Maintenance Level Unit a. Exterior Handle Adjustment 1. Loosen nut (4). 2. Remove capscrew (2) and boss (3) from latch (1). 3. Adjust boss (3) until rod (5) contacts end of slot,(6) with door handle (18) in contact with lower flange (19) and bolt hole in boss (3) aligns with threaded hole in latch (1). 4. Install capscrew (2) on boss (3) and tighten nut (4). b. Interior Handle Adjustment 1. Close latch (1). 2. Tighten or loosen nut, (14) until handle (18) releases latch (1) prior to detent pin (9) bottoming in recess of lock rod (12). c. Locking Rod Adjustment 1. Loosen two nuts (7) on clevises (8). 2. Remove two screws (13) and clevises (8) from locking rod bracket (11). 3. Position detent pin (9) to upper hole (17) in detent bracket (10). 4. Adjust clevises (8) until lock pawls (16) are If2 in. (12.7 mm) from door channel (15) and bolt holes in clevises (8) align with threaded holes in locking rod bracket (11). 5. Install clevises (8) on locking rod bracket. (11) with two screws (13). 6. Tighten two nuts (7) on clevises (8). 11-18